How To Install Above Ground Pool Liner. Remove the pool’s railing and pull the liner over one side of the pool, using clamps to hold it in place. Installing a round overlap liner.
How to Install an Overlap Liner for your Above Ground Pool Swimming from www.pinterest.com
Using spray glue or duct tape attach the pool wall foam to the metal pool wall. All the air will begin to be sucked out from between the liner. Feed the liner's bead into the receiver, making sure the bead fits securely in the track.
Unfold The Liner And Spread It Along The Pool Floor.
With a combined 50+ years of experience the pool factory employs a highly trained staff of above ground and semi inground pool specialists. Reinstall the pool top rails as per the manufacturer's instructions. Do not use a knife or any sharp instrument that will cut through the carton and potentially damage the liner.
Installing A Round Overlap Liner.
Unfold the liner and spread it in the sun to warm up. Going back and forth will ensure the liner is as even as possible. Feed the liner's bead into the receiver, making sure the bead fits securely in the track.
Remove The Pool’s Railing And Pull The Liner Over One Side Of The Pool, Using Clamps To Hold It In Place.
If you use a beaded liner, you can use the sticks to hold it in place. Hang the liner over the wall of the pool with the seam straight up and down or perpendicular to the floor to ensure the liner goes. Then, insert the hose of a commercial duty shop vac into your skimmer until it is in between the liner and the wall a few inches down the pool wall.
The Suction Opening Of The Hose Will Be 6 To 12 Above The Cove Area.
Installing a round overlap liner. Drain the water from the pool and remove it’s old liner. This will leave a small portion of the bottom of the pool wall not covered with foam but this area will be hidden with a sand or foam cove.
If You Use Overlap Liner, You Can Temporarily Put It In Place By Using The Clamps Then Adjust The Position Of The Liner To Suit The Shape Of The Pool.
Install the pool's top rails as per the manufacturer's instructions. Insert the beaded edge of the pool liner in the. Starting at the liners wall same, place your liner on top of the pool wall, print side facing up with the flaps for the seams facing down.
Share
Post a Comment
for "How To Install Above Ground Pool Liner"
Post a Comment for "How To Install Above Ground Pool Liner"